Anytime you are working on your sump pump it should be disconnected from the power.
Tethered float switch adjustment.
Test with bucket of water.
Make sure the pump operates at the desired levels.
Next manually or electronically adjust the float switch up or down based on the water level in.
Adjust float up or down.
The pump will continue to operate until the float drops low enough to disengage the switch.
To order a pump for your diy grey water project email sales greywaterdiy co za south africa or click here to order from amazon.
Attach the float switch to the top of the pump.
The float controls an on off switch for the pump.
Pump sold separately.
Rod settings are made by sliding the sump float up and down the desired.
Step by step disconnect from power.
When the float rises to a pre set height the pump will be switched on.
Efore tightening adjust tether length.
The float switch through at least two complete cycles.
The pump is then idle until the water level rises again.