Our shower room needs revamping.
Tearing out bathroom tile on walls.
Tim carter a builder and nationally syndicated newspaper columnist recommends using oxygen bleach which is a powder that mixes with water.
And even if your removal is perfect tile will chip and send little bits flying like in parts of the room that might also contain an eye or two.
Then pull the drywall and tile off the wall.
Place a pry bar against this line and lever away large sections of the wall.
Tearing out tile 1.
Use that same drywall saw to cut a few hand holes right along the edge of the tiles so you can get a gloved hand in it.
I hope you will follow me through the proc.
Break up the row of tiles right next to the tub.
Chisel out a row of tiles from the center of each wall vertically to the ceiling as well as any tiles that connect.
In contrast says deborah a remodel is all or nothing and you can count on throwing out 99 9 percent of everything in the room says burnett.
These are all updates that do not require re plumbing which in turn requires tearing out walls or new floor plans wiring or lighting.
Chip away the rounded bullnose tiles from the edge and top of a shower with a hammer and chisel.
Cut along the edge of the wall studs if.
Hitting anything with a hammer in general tends to be noisy and tile and grout in particular is very loud.
Then run a drywall saw along the edge of the remaining tiles on all walls.
Start with the 2 side walls until they are out.
In my case i wound up with a bloody calf.
Finish up on the back wall.
So in this video i will show you the part 1 where i removed the bathroom tiles.
Position the chisel at the top of the tiles and hit it firmly with.
Cut through the drywall along the edge of the tiles with a utility knife.